SD-WAN
  • Architecture
  • Using the web application
  • Spaces
  • Bonds
  • Aggregators
  • Nodes
  • Private WAN
  • Dynamic Routing
  • Policies
  • Users, groups, and permissions
  • Extending SD-WAN
  • Administration
  • IPv6 Compatibility
  • Technical support
  • Software releases and upgrades
  • Laywire (SD-WAN 7) (Preview)
    • Architecture
    • Nodes
      • Installation and setup
        • Initial configuration
        • Installing a node via ISO
        • Installing a node on an existing Linux installation
        • Configuring a default node via web service
        • Configuring a default node or reconfiguring an existing node via USB key
        • Resetting a node to the default configuration
      • Node management
      • Upgrading nodes
      • CLI
    • Interfaces and addressing
    • Peers
    • Node groups
    • Access rules
    • Differences from SD-WAN version 6.x
  • Application Notes
  • Release notes
  • Service bulletins
  • Appendices
SD-WAN
  • »
  • Laywire (SD-WAN 7) (Preview) »
  • Nodes »
  • Installation and setup

Installation and setupΒΆ

There a variety of ways to install and set up nodes. The following pages provide detailed instructions.

  • Initial configuration
  • Installing a node via ISO
  • Installing a node on an existing Linux installation
  • Configuring a default node via web service
  • Configuring a default node or reconfiguring an existing node via USB key
  • Resetting a node to the default configuration
Next Previous